AGFA DR 600 - Controls for digital tomosynthesis

Controls for digital tomosynthesis
1
2
3
5
4
1.
Radiographic parameters for acquisition
2.
Positioning controls for acquisition
3.
Recontruction parameters
4.
Dose adaptation for patient size
5.
Button to start the digital tomosynthesis workflow
Figure 73: Controls for digital tomosynthesis
The two point working mode applies to the radiographic parameters. The
value of kV and mAs can be adjusted. Other working modes are not available.
Related Links
Performing a digital tomosynthesis examination on page 101
Topics:
• Radiographic Parameters for digital tomosynthesis
• Position parameters for digital tomosynthesis
• Reconstruction parameters
• Adjusting the reconstruction settings for digital tomosynthesis
DR 600 | Software Console and Tube Head Display | 173
3261K EN 20210708 0808