The status indicator on the remote control is blinking slowly to indicate
that battery charging is ongoing.
The status indicator on the remote control is unlit when the battery is fully
charged.
Charging time maximum 10 hours
Operation time when fully charged 2.5 hours continuous operation or 1
day normal use
Standby time when fully charged 7 days
Remote control status indicator light
Table 1: Status of the remote control
Blinking fast communication with the X-ray system is inter-
rupted
Lighting up while pressing
any button
battery charge level is low
Table 2: Status of the remote control when it is in the charging unit
Blinking slow battery charging is ongoing
Off battery is fully charged
26 | DR 600 | Introduction
3261K EN 20210708 0808
To Next Page
Loading...
