AGFA DR 600 - Page 3

Warning labels on the radiographic wall stand .
58
Type label .................................................... 59
DR Detector identification label ................... 60
Additional Labeling of the Tube Head Unit ... 61
Additional Labeling of the Radiographic Table .
62
Additional Labeling of the Radiographic Wall
Stand ...........................................................63
Labeling of the bucky ...................................64
Labeling of the Automatic Exposure Control (AEC)
..........................................................................66
Labeling of the DR Generator Sync Box ........ 67
Labeling of the X-ray generator (Spellman) ....
68
Labeling of the X-ray generator (EMD) .........70
Labeling of the Remote Control ....................71
Labeling of components with earthquake
resistance .....................................................72
About the software ...................................... 73
Cleaning and Disinfecting ........................................ 74
Cleaning ...................................................... 75
Disinfecting ................................................. 77
Disinfecting safety directions ....................... 78
Approved disinfectants ................................ 79
Maintenance ............................................................80
Maintenance of the radiographic table,
radiographic wall stand and X-Ray Tube Head Unit
..........................................................................80
Safety Directions ..................................................................84
General Safety Directions .........................................85
Safety Directions for the X-Ray System .....................87
Safety Directions for the radiographic table ............. 89
Safety Directions for the Ceiling Suspension ............ 90
Basic Workflow ....................................................................91
Starting the System ................................................. 92
Automated workflow for warming-up of X-ray
tube ............................................................ 92
Performing an exposure using the DR Detector ........ 94
Step 1: retrieve the patient info ....................95
Step 2: select the exposure ...........................96
Step 3: Prepare the exposure ........................97
Step 4: Check the exposure settings ............. 98
Step 5: execute the exposure ........................99
Step 6: perform a quality control ................100
Performing a digital tomosynthesis examination .... 101
Step 1: prepare the examination ................ 102
Step 2: position the X-ray system and the patient
........................................................................105
Step 3: check the exposure settings ............ 106
DR 600 | Contents |
iii
3261K EN 20210708 0808