2D-LC User Guide 99
4Installation
Software Installation
Configure the Device UI
1 Define names of modules (device name).
Possible options are, for example, the following:
• Sampler
• Iso Pump
•
1
D Bin Pump
•
1
D MCT,
•
2
D MCT,
•
1
D DAD,
•
2
D DAD,
For an example, see Figure 46 on page 100.
2 It is recommended to change order of column compartments and detectors.
Use the arrow.
A meaningful order is helpful for the overview of the dashboard and signal
naming (e.g. the detector further left, in qual analysis, will be named as signal
1, e.g. DAD1).
To Next Page
Loading...
