38 Agilent 4150 TapeStation System Manual
4
Installation
Unpacking
Unpacking
For unpacking the instrument follow the instructions listed below.
Do not remove the instrument from its original shipping box immediately.
Upon delivery, store in a temperature stable, dry environment suitable for
operation, see “Physical Specification” on page 32. If actual shipment
conditions are unknown or were outside operating conditions, wait for at least
5 h before unpacking to allow the instrument to adjust to the ambient
temperature and humidity of the operating environment.
1 Place the instrument box on the floor and cut it open.
Heavy weight
The instrument is heavy.
➔ Avoid back strain or injury by following all precautions for lifting heavy objects.
➔ Ensure that the load is as close to your body as possible.
➔ Ensure that you can cope with the weight of your load.
Condensation within the module
Condensation can damage the system electronics.
➔ Do not store, ship or use your module under conditions where temperature
fluctuations could cause condensation within the module.
➔ If your module was shipped in cold weather, leave it in its box and allow it to warm
slowly to room temperature to avoid condensation.
To Next Page
Loading...
Need help?
General
