Agilent 4150 TapeStation System Manual 45
Installation
4
Initial Setup of the System
Initial Setup of the System
Hazard of electrical shock or damage of your instrumentation
can result, if the devices are connected to a line voltage higher than specified.
➔ Connect your instrument to the specified line voltage only.
Electrical shock hazard
The module is partially energized when switched off, as long as the power cord is
plugged in.
The cover protects users from personal injuries, for example electrical shock.
➔ Do not open the cover.
➔ Do not operate the instrument and disconnect the power cable in case the cover
has any signs of damage.
➔ Contact Agilent for support and request an instrument repair service.
Inaccessible power plug.
In case of emergency it must be possible to disconnect the instrument from the
power line at any time.
➔ Make sure the power connector of the instrument can be easily reached and
unplugged.
➔ Provide sufficient space behind the power socket of the instrument to unplug the
cable.
To Next Page
Loading...
Need help?
General
