Setting Up
The modules of the automatic liquid sampler
3
The modules of the automatic liquid sampler
The automatic liquid sampler is made up of three modules:
The automatic liquid sampler works with the PrepStation system to automate
sample preparation procedures. The G1296A/G1926A bar code reader module
is also available. It reads the vial numbers and special instructions for running
a method. It can also be used for agitating the sample vial.
The automatic liquid sampler becomes part of your gas chromatography
system. It introduces sample to an inlet or a column on your GC.
The automatic liquid sampler, with or without the tray, can be controlled by a
variety of integrators and computers, including:
• 6890 Series GC
• Its own electronics (standalone control)
• 3396 integrators plus older models
• Most Agilent laboratory automation systems
• Most Agilent ChemStation systems
• Suitably programmed external computers
The G1512A controller and communications module supplies
power and communications to the injector and tray.
The G1513A injector module removes a volume of sample from
a vial and injects it into the inlet.
The 18596C tray module moves sample vials to and from the
injector and the bar code reader.
"6890" [type C] tower, tray and controller
To Next Page
Loading...
