Operation
Special considerations when using an integrator with a 6890 Series GC
82
Figure 46 shows an example of the injector parameter portion of a method
printout using a 6890 Series GC, a 3396 integrator, and a G1513A injector in the
front position and a 18593B in the back position.
Figure 46. Injector parameters on a 3396 integrator with a 6890 GC
* LIST: METH @
INJECTOR 1
Injection vol 1
#Sample pumps 5
Viscosity delay 0
#Sample washes 1
#Solv A washes 3
#Solv B washes 3
Slow plunger Off
Pre dwell time 0.00
Post dwell 0.00
Sampling offset On
Offset 0.0
#Solv A pre wash 0
#Solv B pre wash 0
Front tower INJ1
Waste bottle use 2
*
INJECTOR 2
Injection vol 1
#Sample pumps 6
Viscosity delay 0
#Sample washes 0
#Solv A washes 0
#Solv B washes 0
Slow injection Off
Back tower INJ2
Waste bottle use 2
To Next Page
Loading...
