154 6000 Series Oscilloscope User’s Guide
4 Triggering the Oscilloscope
4 Press the BUSDOCTOR 2 softkey to access the BUSDOCTOR 2
Menu.
Specifying the BUSDOCTOR LAN Address
This is necessary when the oscilloscope controls BUSDOCTOR
(but not when a PC with VISION software controls
BUSDOCTOR).
1 From the BUSDOCTOR 2 Menu, press the LAN Address softkey
to access the BUSDOCTOR LAN Addresses Menu.
2 Enter the BUSDOCTOR’s 4-byte IP address:
a Press the Value softkey and use the Entry knob to select a
byte value.
b Press the Next softkey to access the next byte.
3 When you have finished entering the IP address, press the
Apply softkey.
This is sufficient for connection via a hub or switch.
If the oscilloscope is connected directly to the BUSDOCTOR (in
a point-to-point configuration), the following additional steps
must be taken.
Baud Rate
Mode
Channel
FlexRay
trigger
Return to
previous menu
TDMA Struct
(Sync Mode)
BUSDOCTOR
LAN Address
To Next Page
Loading...
Need help?
General
