Saving and Printing Data 7
6000 Series Oscilloscope User’s Guide 313
To AutoSave traces and setups
1 Connect a signal to the oscilloscope and obtain a stable
display.
2 Connect a USB mass storage device to the USB port on the
front panel or the rear panel.
3 Press the Save/Recall key.
4 Turn the Entry knob and then press the far left softkey to
select a directory on a USB mass storage device.
5 Press the Press to AutoSave softkey.
Your current setup and waveform trace will be saved to files
using automatically generated file names (QFILE_nn) on the
USB mass storage device. The file name is shown in the line
above the softkeys.
The nn number in the QFILE_nn file name will automatically
increment (starting at 00) each time you save a new file to the
USB mass storage device.
NOTE
Regarding USB Ports:
The USB port on the front panel and the USB port on the rear panel labeled
“HOST” are USB Series A receptacles. These are the receptacles to which
you can connect USB mass storage devices and printers.
The square receptacle on the rear panel labeled “DEVICE” is provided for
controlling the oscilloscope over USB. See the 6000 Series Oscilloscopes
Programmer’s Quick Start Guide or the 6000 Series Oscilloscopes
Programmer’s Reference for more information. To access these
documents online, point your web browser to
www.agilent.com/find/mso6000 and select Library.
If two USB mass storage devices are connected to the oscilloscope, the
first one is designated “drive0” and the second one is designated “drive5,”
not “drive1.” This numbering method is normal; it is inherent in the USB
driver.
To Next Page
Loading...
Need help?
General
