314 6000 Series Oscilloscope User’s Guide
7 Saving and Printing Data
When viewed from the File Explorer Menu (Utility&File Explorer)
the trace file will have a TRC file extension and the setup file
will have a SCP file extension.
To save traces and setups to internal memory or to overwrite an existing
USB mass storage device file
1 If you will be saving a trace and/or setup to a USB mass
storage device, connect the device to the oscilloscope.
2 Press the Save/Recall key.
3 Press the Save softkey to display the Save menu.
4 Turn the Entry knob and press the far left softkey to select
an internal memory file or USB mass storage device file to be
overwritten.
In the following screen image:
• drive0 is a USB mass storage device which has been
connected to the oscilloscope.
• C: is the root directory of the oscilloscope’s internal memory.
• intern0 through intern9 are the internal nonvolatile memory
locations that can be used for storing setups and traces.
• Use the <up> selection to move up one level in the directory
structure.
To Next Page
Loading...
Need help?
General
