260 6000 Series Oscilloscope User’s Guide
6 Displaying Data
Normal Mode
In Normal mode at slower sweep speeds, extra samples are
decimated (in other words, some are thrown away). This mode
yields the best display for most waveforms.
Peak Detect Mode
In Peak Detect mode at slower sweep speeds, minimum and
maximum samples are kept in order to capture infrequent and
narrow events (at the expense of exaggerating any noise). This
mode displays all pulses that are at least as wide as the sample
period (see Table 16).
Table 16 Agilent 6000 Series Model Numbers and Sampling Rates
High Resolution Mode
In High Resolution mode, at slower sweep speeds extra samples
are averaged in order to reduce random noise, produce a
smoother trace on the screen, and effectively increase vertical
resolution.
High Resolution mode averages sequential sample points within
the same acquisition together. An extra bit of vertical resolution
is produced for every factor of 4 averages. The number of extra
bits of vertical resolution is dependent on the time per division
setting (sweep speed) of the scope.
The slower the sweep speed, the greater the number of samples
that are averaged together for each display point.
Bandwidth 100 MHz 300 MHz 500 MHz 1 GHz
Maximum Sample Rate 2GSa/s 2GSa/s 4GSa/s 4GSa/s
A sample is taken every
(sample period)
500 ps 500 ps 250 ps 250 ps
2-Channel DSO DSO6012A DSO6032A DSO6052A DSO6102A
4-Channel DSO DSO6014A DSO6034A DSO6054A DSO6104A
2-Channel + 16 Logic Channels MSO MSO6012A MSO6032A MSO6052A MSO6102A
4-Channel + 16 Logic Channels MSO MSO6014A MSO6034A MSO6054A MSO6104A
4-Channel DSO DSO6014L DSO6054L DSO6104L
To Next Page
Loading...
Need help?
General
