Saving and Printing Data 7
6000 Series Oscilloscope User’s Guide 307
To print the display to a USB printer
A USB printer can be connected to the oscilloscope through a
USB host port on the front or rear of the oscilloscope. (The USB
host ports are rectangular; the USB device port is square.) You
need a USB cable to connect the printer.
1 Connect the printer to the USB port on either the front or the
rear of the oscilloscope. A list of supported printers is given
on page 308.
2 To access the Print Config menu, press Utility&Print Config.
3 Press the Print to softkey and select the printer.
If the oscilloscope identifies the printer you have connected,
the oscilloscope will choose the correct driver.
If the oscilloscope does not automatically choose the driver
for your printer, use the Driver softkey and the Entry knob to
select the correct driver for your printer. Choose Generic if
you don't know which driver to use.
4 Press the Quick Print key on the front panel.
5 To make subsequent printouts, simply press the Quick Print
key.
To Next Page
Loading...
Need help?
General
