Reference 8
6000 Series Oscilloscope User’s Guide 323
To set up the I/O port
The oscilloscope can be controlled via GPIB, LAN, or USB.
The oscilloscope’s I/O configuration, including its IP address
and hostname, can be viewed by pressing Utility
&I/O.
To change the I/O controller settings, press the Configure softkey,
and choose the I/O connection type (GPIB, LAN, or USB).
For instructions on setting up the oscilloscope to run from a
controller via LAN, GPIB, or USB, see the Agilent 6000 Series
Oscilloscopes Programmer’s Quick Start Guide.
To Next Page
Loading...
Need help?
General
