300 6000 Series Oscilloscope User’s Guide
6 Displaying Data
Specifying the Channels Displayed After AutoScale
The Channels softkey selection determines which channels will
be displayed on subsequent AutoScales.
• All Channels — The next time you press AutoScale, all channels
that meet the requirements of AutoScale will be displayed.
• Only Displayed Channels — The next time you press AutoScale,
only the channels that are turned on will be examined for
signal activity. This is useful if you only want to view specific
active channels after pressing AutoScale.
Preserving the Acquisition Mode During AutoScale
The acquisition mode is normally switched to Normal when
AutoScale is performed. AutoScale can be set to leave the
acquisition mode unchanged if you prefer this option.
Choose Normal to make the oscilloscope switch to Normal
acquisition mode whenever the AutoScale key is pressed. This is
the default mode.
Choose Preserve to make the oscilloscope remain in the
acquisition mode you have chosen when the AutoScale key is
pressed.
To Next Page
Loading...
Need help?
General
