326 6000 Series Oscilloscope User’s Guide
8 Reference
To synchronize the timebase of two or more instruments
The oscilloscope can output it’s 10 MHz system clock for the
purpose of synchronization with other instruments.
1 Connect a BNC cable to the BNC connector labeled 10 MHz
REF on the rear panel of the oscilloscope.
2 Connect the other end of the BNC cable to the instrument(s)
that will accept the 10 MHz reference signal. Put a 50 Ω
termination at the input to the other instrument to terminate
the signal.
3 Press Utility&Options&Rear Panel&Ref Signal.
4 Use the Entry Knob and the Ref Signal softkey to select 10 MHz
output.
The oscilloscope will output it’s 10 MHz reference signal at TTL
levels.
To check warranty and extended services status
To learn the warranty status of your oscilloscope:
1 Point your web browser to:
www.agilent.com/find/warrantystatus
2 Enter your product’s model number and serial number. The
system will search for the warranty status of your product
and display the results. If the system cannot find your
product’s warranty status, select Contact Us and speak with
an Agilent Technologies representative.
To Next Page
Loading...
Need help?
General
