228 6000 Series Oscilloscope User’s Guide
5 Making Measurements
The difference between Y1 and Y2 (∆Y) is displayed on
the dedicated line above the softkeys or in the display
area when some menus are selected.
Turn the Entry knob to adjust the Y1 or Y2 cursor
when its softkey is selected.
• X1 X2 — Press this softkey to adjust the X1 and X2
cursors together by turning the Entry knob. The ∆X
value will remain the same since the cursors adjust
together.
You can adjust the X cursors together to check for
pulse width variations in a pulse train.
• Y1 Y2 — Press this softkey to adjust the Y1 and Y2
cursors together by turning the Entry knob. The ∆Y
value will remain the same since the cursors adjust
together.
To Next Page
Loading...
Need help?
General
