Saving and Printing Data 7
6000 Series Oscilloscope User’s Guide 319
4 To load a file into the oscilloscope press the Load File softkey.
Files that can be loaded into the oscilloscope:
• QFILE_nn.SCP setup files, QFILE_nn.TRC trace files,
and other user-defined setup or trace files that were
created using the Save/Recall key on the front panel of the
oscilloscope.
• Localized language pack files (LANGPACK.JZP).
• System software files (*.BIN and *.JZP).
Files that cannot be loaded into the oscilloscope:
• Any PRINT_nn.xxx printer file.
• Any other file not created by the oscilloscope.
5 To delete a file from the USB mass storage device, press the
Delete File softkey.
NOTE
If two USB mass storage devices are connected to the oscilloscope, the
first one is designated “drive0” and the second one is designated “drive5,”
not “drive1.” This numbering method is normal; it is inherent in the USB
driver.
NOTE
Deleted files cannot be recovered
A file that has been deleted from the USB mass storage device cannot be
recovered by the oscilloscope.
To Next Page
Loading...
Need help?
General
