ETH-CFM Configuration Commands
Page 116 7210 SAS M Services Guide
name ma-name — Specifies the part of the maintenance association identifier which is unique within
the maintenance domain name.
Values 1 — 45 characters
bridge-identifier
Syntax [no] bridge-identifier bridge-id
Context config>eth-cfm>domain>association
Description This command configures the service ID for the domain association. The value must be configured to
match the service-id of the service where MEPs for this association will be created. Note that there is
no verification that the service with a matching service-id exists. This is not used for facility MEPs as
they are not tied to services.
Parameters bridge-id — Specifies the bridge ID for the domain association.
Values 1 — 2147483647
mhf-creation
Syntax mhf-creation {none | explicit}
no mhf-creation
Context config>eth-cfm>domain>association>bridge-identifier
Description This command determines whether to allow automatic MIP creation for the MA.
Default none
Parameters none — Specifies that no MHFs can be created for this VID.
explicit — Specifies that MHFs can be created for this VID only on bridge ports through which this
VID can pass, and only if a MEP is created at some lower MA level. There must be at least one
lower level MEP provisioned on the same SAP.
vlan
Syntax vlan vlan-id
no vlan
Context config>eth-cfmg>domain>association>bridge-identifier
Description This command configures the bridge-identifier primary VLAN ID. Note that it is informational only,
and no verification is done to ensure MEPs on this association are on the configured VLAN.
Parameters vlan-id — Specifies a VLAN ID monitored by MA.
Values 0 — 4094
To Next Page
Loading...
Need help?
General
