Virtual Leased Line Services
7210 SAS M Services Guide Page 227
Connection Profile Commands
connection-profile
Syntax connection-profile conn-prof-id [create]
no connection-profile conn-prof-id
Context config
Description This command creates a list of VLAN values to be assigned to a Dot1q SAP in an Epipe service.
A connection profile can only be assigned to a Dot1q SAP which is part of an Epipe Service.
The no form of this command deletes the profile from the configuration.
Default none
Parameters conn-prof-id — Specifies the profile number.
Values 1 — 8000
ethernet
Syntax ethernet
Context config>connprof
Description Provides the context to configure the VLAN ranges values.
Default none
ranges
Syntax no ranges
ranges vlan-ranges [vlan-ranges...(upto 32 max)]
Context config>connprof>ethernet
Description Specifies the list of VLAN ranges or individual VLAN ID to be used for mapping the given VLANs
to the Epipe SAP.
The system validates that the values specified are valid VLAN ID in the range 0-4094 (VLAN ID
4095 is reserved). Ranges are specified in the format ‘a-b ’, the expression (a < b) should be true. Up
to about 32 individual VLAN values or VLAN ranges can be specified. A maximum of up to 8 VLAN
ranges are allowed per connection profile.
Default none
To Next Page
Loading...
