Virtual Private LAN Services
7210 SAS M Services Guide Page 379
Parameters endpoint-name — Specifies an endpoint name up to 32 characters in length.
create — This keyword is mandatory while creating a service endpoint.
description
Syntax description description-string
no description
Context config>service>vpls>endpoint
This command creates a text description stored in the configuration file for a configuration context.
The description command associates a text string with a configuration context to help identify the
content in the configuration file.
The no form of this command removes the string from the configuration.
Default No description associated with the configuration context.
Parameters string — The description character string. Allowed values are any string up to 80 characters long
composed of printable, 7-bit ASCII characters. If the string contains special characters (#, $,
spaces, etc.), the entire string must be enclosed within double quotes.
ignore-standby-signaling
Syntax [no] ignore-standby-signaling
Context config>service>vpls>endpoint
config>service>vpls>spoke-sdp
Description When this command is enabled, the node will ignore standby-bit received from TLDP peers for the
given spoke SDP and performs internal tasks withot taking it into account.
This command is present at endpoint level as well as spoke SDP level. If the spoke SDP is part of the
explicit-endpoint, it is not possible to change this setting at the spoke SDP level. The existing spoke
SDP will become part of the explicit-endpoint only if the setting is not conflicting. The newly created
spoke SDP which is a part of the given explicit-endpoint will inherit this setting from the endpoint
configuration.
Default disabled
revert-time
Syntax revert-time revert-time | infinite
no revert-time
Context config>service>vpls>endpoint
Description This command configures the time to wait before reverting to primary spoke SDP.
To Next Page
Loading...
Need help?
General
