Alcatel-Lucent 7210 SAS M Service Guide

Virtual Private LAN Services
Page 380 7210 SAS M Services Guide
In a regular endpoint the revert-time setting affects just the pseudowire defined as primary
(precedence 0). For a failure of the primary pseudowire followed by restoration the revert-timer is
started. After it expires the primary pseudowire takes the active role in the endpoint. This behavior
does not apply for the case when both pseudowires are defined as secondary. For example, if the
active secondary pseudowire fails and is restored it will stay in standby until a configuration change
or a force command occurs.
Parameters revert-time — Specifies the time to wait, in seconds, before reverting back to the primary spoke SDP
defined on this service endpoint, after having failed over to a backup spoke SDP.
Values 0 — 600
infinite — Specifying this keywork makes endpoint non-revertive.
split-horizon-group
Syntax split-horizon-group group-name [create]
Context config>service>pw-template
Description This command is used to create a new split horizon group for the VPLS instance. Traffic arriving on a
SAP or spoke SDP within this split horizon group will not be copied to other SAPs or spoke SDPs in
the same split horizon group.
A split horizon group must be created before SAPs and spoke SDPs can be assigned to the group. The
split horizon group is defined within the context of a single VPLS instance. The same group-name
can be re-used in different VPLS instances.
Note: In 7210-SAS devices, use of SAP or spoke-SDP Split-horizon group and Mesh-SDP are
mutually exclusive.
The no form of the command removes the group name from the configuration.
Parameters group-name — Specifies the name of the split horizon group to which the SAP or Spoke-SDP
belongs.
create — Mandatory keyword to create a split-horizon group.
static-mac
Syntax static-mac ieee-address [create]
no static-mac
Context config>service>vpls>endpoint
Description This command assigns a static MAC address to the endpoint. In the FDB, the static MAC is then
associated with the active spoke SDP.
Default none
Parameters ieee-address — Specifies the static MAC address to the endpoint.
Values 6-byte mac-address (xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx). (Note: This value
cannot be all zeros.)

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English