Virtual Private LAN Services
7210 SAS M Services Guide Page 381
create — This keyword is mandatory while creating a static MAC.
suppress-standby-signaling
Syntax [no] suppress-standby-signaling
Context config>service>vpls>endpoint
Description When this command is enabled, the pseudowire standby bit (with value 0x00000020) will not be sent
to T-LDP peer when the given spoke is selected as a standby. This allows faster switchover as the
traffic will be sent over this SDP and discarded at the blocking side of the connection. This is
particularly applicable to multicast traffic.
Default enabled
propagate-mac-flush
Syntax [no] propagate-mac-flush
Context config>service>vpls
Description This command specifies whether MAC flush messages received from the given LDP are propagated
to all spoke and mesh SDPs within the context of this VPLS service. The propagation will follow the
split-horizon principle and any data-path blocking in order to avoid the looping of these messages.
Default no propagate-mac-flush
fdb-table-high-wmark
Syntax [no] fdb-table-high-wmark high-water-mark
Context config>service>vpls
Description
This command specifies the value to send logs and traps when the threshold is reached.
Parameters high-water-mark — Specify the value to send logs and traps when the threshold is reached.
Values 0— 100
Default 95%
fdb-table-low-wmark
Syntax [no] fdb-table-low-wmark low-water-mark
Context config>service>vpls
Description
This command specifies the value to send logs and traps when the threshold is reached.
To Next Page
Loading...
Need help?
General
