Alcatel-Lucent 7210 SAS M - Page 410

Virtual Private LAN Services
Page 410 7210 SAS M Services Guide
ETH-CFM Service Commands
eth-cfm
Syntax eth-cfm
Context config>service>vpls
config>service>vpls>mesh-sdp
config>service>vpls>spoke-sdp
config>service>vpls>sap
Description This command enables the context to configure ETH-CFM parameters.
mep
Syntax mep mep-id domain md-index association ma-index [direction {up | down}]
no mep mep-id domain md-index association ma-index
Context config>service>vpls>mesh-sdp>eth-cfm
config>service>vpls>sap>eth-cfm
Description This command configures the ETH-CFM maintenance endpoint (MEP).
Parameters mep-id — Specifies the maintenance association end point identifier.
Values 1 — 8191
md-index — Specifies the maintenance domain (MD) index value.
Values 1 — 4294967295
ma-index — Specifies the MA index value.
Values 1 — 4294967295
direction up| down — Indicates the direction in which the maintenance association (MEP) faces on
the bridge port. Direction is not supported when a MEP is created directly under the vpls>eth-
cfm construct (vMEP).
down — Sends ETH-CFM messages away from the MAC relay entity.
up — Sends ETH-CFM messages towards the MAC relay entity.
ais-enable
Syntax [no] ais-enable
Context config>service>vpls>mesh-sdp>eth-cfm>mep
config>service>epipe>spoke-sdp>eth-cfm>mep