Virtual Private LAN Services
Page 418 7210 SAS M Services Guide
Description This command enables the context to configure VLAN ranges to be managed by a management
VPLS. The list indicates, for each SAP, the ranges of associated VLANs that will be affected when
the SAP changes state.
This command is only valid when the VPLS in which it is entered was created as a management
VPLS.
default-sap
Syntax [no] default-sap
Context config>service>vpls>sap>managed-vlan-list
Description This command adds a default SAP to the managed VLAN list.
The no form of the command removes the default SAP to the managed VLAN list.
range
Syntax [no] range vlan-range
Context config>service>vpls>sap>managed-vlan-list
Description This command configures a range of VLANs on an access port that are to be managed by an existing
management VPLS.
This command is only valid when the VPLS in which it is entered was created as a management
VPLS, and when the SAP in which it was entered was created on an Ethernet port with encapsulation
type of dot1q.
To modify the range of VLANs, first the new range should be entered and afterwards the old range
removed. See Modifying VPLS Service Parameters on page 351.
Default None
Parameters vlan-range — Specify the VLAN start value and VLAN end value. The end-vlan must be greater than
start-vlan. The format is <start-vlan>-<end-vlan>
Values start-vlan: 0 — 4094
end-vlan: 0 — 4094
To Next Page
Loading...
Need help?
General
