Virtual Private LAN Services
7210 SAS M Services Guide Page 419
VPLS Filter and QoS Policy Commands
egress
Syntax egress
Context config>service>vpls>sap
Description This command enables the context to configure egress filter policies.
If no egress filter is defined, no filtering is performed.
ingress
Syntax ingress
Context config>service>vpls>sap
Description This command enables the context to configure ingress SAP Quality of Service (QoS) policies and
filter policies.
If no sap-ingress QoS policy is defined, the system default sap-ingress QoS policy is used for ingress
processing. If no ingress filter is defined, no filtering is performed.
filter
Syntax filter ip ip-filter-id
filter ipv6 ipv6-filter-id
filter mac mac-filter-id
Context config>service>vpls>sap>egress
config>service>vpls>sap>ingress
config>service>vpls>spoke-sdp>egress
Description This command associates an IP filter policy or MAC filter policy with an ingress or egress Service
Access Point (SAP) or IP interface.
Filter policies control the forwarding and dropping of packets based on IP or MAC matching criteria.
There are two types of filter policies: IP and MAC. Only one type may be applied to a SAP at a time.
The filter command is used to associate a filter policy with a specified filter ID with an ingress or
egress SAP. The filter ID must already be defined before the filter command is executed. If the filter
policy does not exist, the operation will fail and an error message returned.
In general, filters applied to SAPs (ingress or egress) apply to all packets on the SAP. One exception
is non-IP packets are not applied to IP match criteria, so the default action in the filter policy applies
to these packets.
The no form of this command removes any configured filter ID association with the SAP or IP
interface. The filter ID itself is not removed from the system.
To Next Page
Loading...
Need help?
General
