Virtual Private LAN Services
Page 430 7210 SAS M Services Guide
import
Syntax import policy-name
no import
Context config>service>vpls>sap>igmp-snooping
config>service>vpls>spoke-sdp>igmp-snooping
config> service>vpls> mesh-sdp>igmp-snooping
config>service>pw-template>igmp-snooping
Description This command specifies the import routing policy to be used for IGMP packets to be used on this
SAP or SDP. Only a single policy can be imported on a single SAP or SDP at any time.
The no form of the command removes the policy association from the SAP or SDP.
Default no import — No import policy is specified.
Parameters policy-name — The import policy name. Values can be string up to 32 characters long of printable, 7-
bit ASCII characters. If the string contains special characters (#, $, spaces, etc.), the entire string
must be enclosed within double quotes. These policies are configured in the config>router>
policy-options context The router policy must be defined before it can be imported.
last-member-query-interval
Syntax last-member-query-interval tenths-of-seconds
no last-member-query-interval
Context config>service>vpls>sap>igmp-snooping
config>service>vpls>spoke-sdp>igmp-snooping
config>service>vpls>mesh-sdp>igmp-snooping
config>service>pw-template>igmp-snooping
Description This command configures the maximum response time used in group-specific queries sent in
response to ‘leave’messages, and is also the amount of time between 2 consecutive group-specific
queries. This value may be tuned to modify the leave latency of the network. A reduced value results
in reduced time to detect the loss of the last member of a group.
The configured last-member-query-interval is ignored when fast-leave is enabled on the SAP or SDP.
Default 10
Parameters seconds — Specifies the frequency, in tenths of seconds, at which query messages are sent.
Values 1 — 50
max-num-groups
Syntax max-num-groups count
no max-num-groups
Context config>service>vpls>sap>igmp-snooping
config>service>vpls>spoke-sdp>igmp-snooping
To Next Page
Loading...
