EasyManuals Logo

Alcatel-Lucent 7210 SAS M Service Guide

Alcatel-Lucent 7210 SAS M
952 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #431 background imageLoading...
Page #431 background image
Virtual Private LAN Services
7210 SAS M Services Guide Page 431
config>service>vpls>mesh-sdp>igmp-snooping
config>service>pw-template>igmp-snooping
Description This command defines the maximum number of multicast groups that can be joined on this SAP or
SDP. If the node receives an IGMP join message that would exceed the configured number of groups,
the request is ignored.
Default no max-num-groups
Parameters count — Specifies the maximum number of groups that can be joined on this SAP or SDP.
mrouter-port
Syntax [no] mrouter-port
Context config>service>vpls>sap>igmp-snooping
config>service>vpls>spoke-sdp>igmp-snooping
config>service>vpls>mesh-sdp>igmp-snooping
Description This command specifies whether a multicast router is attached behind this SAP.
Configuring a SAP or SDP as an mrouter-port will have a double effect. Firstly, all multicast traffic
received on another SAP or SDP will be copied to this SAP or SDP. Secondly, IGMP reports
generated by the system as a result of someone joining or leaving a multicast group, will be sent to
this SAP or SDP.
If two multicast routers exist in the network, one of them will become the active querier. While the
other multicast router (non-querier) stops sending IGMP queries, it should still receive reports to keep
its multicast trees up to date. To support this, the mrouter-port should be enabled on all SAPs or SDPs
connecting to a multicast router.
Note that the IGMP version to be used for the reports (v1or v2) can only be determined after an initial
query has been received. Until such time no reports are sent on the SAP or SDP, even if mrouter-port
is enabled.
If the send-queries command is enabled on this SAP, the mrouter-port parameter can not be set.
Default no mrouter-port
mvr
Syntax mvr
Context config>service>vpls>igmp-snooping
config>service>vpls>sap>igmp-snooping
Description This command enables the context to configure Multicast VPLS Registration (MVR) parameters.

Table of Contents

Other manuals for Alcatel-Lucent 7210 SAS M

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alcatel-Lucent 7210 SAS M and is the answer not in the manual?

Alcatel-Lucent 7210 SAS M Specifications

General IconGeneral
BrandAlcatel-Lucent
Model7210 SAS M
CategorySwitch
LanguageEnglish

Related product manuals