Virtual Private LAN Services
Page 432 7210 SAS M Services Guide
query-interval
Syntax query-interval seconds
no query-interval
Context config>service>vpls>igmp-snooping
config>service>vpls>sap>igmp-snooping
config>service>vpls>spoke-sdp>igmp-snooping
config>service>vpls>mesh-sdp>igmp-snooping
config>service>pw-template>igmp-snooping
Description This command configures the IGMP query interval. If the send-queries command is enabled, this
parameter specifies the interval between two consecutive general queries sent by the system on this
SAP or SDP. The configured query-interval must be greater than the configured query-response-
interval. If send-queries is not enabled on this SAP or SDP, the configured query-interval value is
ignored.
Default 125
Parameters seconds — The time interval, in seconds, that the router transmits general host-query messages.
Values 2 — 1024
query-src-ip
Note: This command is supported only on 7210 SAS-M devices configured in Network mode.
Syntax query-src-ip ip-address
no query-src-ip
Context config>service>vpls>igmp-snooping
Description This command configures the IP source address used in IGMP queries.
query-response-interval
Syntax query-response-interval seconds
Context config>service>vpls>sap>igmp-snooping
config>service>vpls>spoke-sdp>igmp-snooping
config>service>vpls>mesh-sdp>igmp-snooping
config>service>pw-template>igmp-snooping
Description This command configures the IGMP query response interval. If the send-queries command is
enabled, this parameter specifies the maximum response time advertised in IGMP queries.
The configured query-response-interval must be smaller than the configured query-interval.
If send-queries is not enabled on this SAP or SDP, the configured query-response-interval value is
ignored.
Default 10
To Next Page
Loading...
