Alcatel-Lucent 7210 SAS M Service Guide

Virtual Private LAN Services
Page 436 7210 SAS M Services Guide
If the send-query command is not configured, the version command has no effectThe version used
on that SAP orwill be the version of the querier.
Note: IGMP V3 is supported only on 7210 SAS-M devices configured in access-uplink mode. IGMP
V3 is not supported on 7210 SAS-M devices configured in network mode.
Parameters version — Specify the IGMP version.
to-sap
Syntax to-sap sap-id
no to-sap
Context config>service>vpls>sap>igmp-snooping>mvr
Description
This command configures the SAP to which the multicast data needs to be copied.
In some scenarios, the multicast traffic should not be copied from the MVR VPLS to the SAP on
which the IGMP message was received (standard MVR behaviour) but to another SAP.
Default no to-sap
Parameters sap-id — Specifies the SAP to which multicast channels should be copied.

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English