Virtual Private LAN Services
7210 SAS M Services Guide Page 435
starg
Syntax [no] starg
Context config>service>vpls>sap>igmp-snooping>static>group
config>service>vpls>spoke-sdp>igmp-snooping>static>group
config>service>vpls>mesh-sdp>igmp-snooping>static>group
Description This command adds a static (*,g) entry to allow multicast traffic for the corresponding multicast
group from any source. This command can only be enabled if no existing source addresses for this
group are specified.
The no form of the command removes the starg entry from the configuration.
Default no starg
static
Syntax static
Context config>service>vpls>sap>igmp-snooping
config>service>vpls>spoke-sdp>igmp-snooping
config>service>vpls>mesh-sdp>igmp-snooping
Description This command enables access to the context to configure static group addresses. Static group
addresses can be configured on a SAP or SDP. When present either as a (*, g) entry, multicast packets
matching the configuration will be forwarded even if no join message was registered for the specific
group.
Default none
version
Syntax version version
no version
Context config>service>vpls>sap>igmp-snooping
config>service>vpls>mesh-sdp>igmp-snooping
config>service>vpls>spoke-sdp>igmp-snooping
config>service>vpls>mesh-sdp>snooping>static
config>service>pw-template>igmp-snooping
Description This command specifies the version of IGMP which is running on this SAP or SDP. This object can
be used to configure a router capable of running either value. For IGMP to function correctly, all
routers on a LAN must be configured to run the same version of IGMP on that LAN.
When the send-query command is configured, all type of queries generate ourselves are of the
configured version. If a report of a version higher than the configured version is received, the report
gets dropped and a new “wrong version” counter is incremented.
To Next Page
Loading...
