Alcatel-Lucent 7210 SAS M - Page 461

VPLS Service Commands
7210 SAS M Services Guide Page 461
source-bmac
Syntax source-bmac ieee-address
no source-bmac
Context config>service>pbb
Description This command configures the base source BMAC for the B-VPLS. The first 32 bits must be the same
with what is configured in the MC-LAG peer. If the base source BMAC is not configured, it inherits
the chassis level BMAC configured under the PBB object added in the previous section.
Parameters ieee-address — The MAC address assigned to the BMAC. The value should be input in either a
xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx format.
backbone-vpls
Syntax backbone-vpls service-id [isid isid]
no backbone-vpls
Context
config>service>vpls
config>service>vpls>pbb
Description This command configures B-VPLS service associated with the I-VPLS.
Parameters service-id — Specifies the service ID.
Values 1..2147483648
isid — Specifies the ISID.
Values 0..16777215