Show Commands
Page 478 7210-SAS M Services Guide
===============================================================================
*A:7210-SAS>show>service#
base
Syntax base
Context show>service>id
Description This command displays basic information about the service including service type, description and
SAPs.
Output Show service ID base output — The following table describes the command output fields.
Label Description
Service Id The service identifier.
Service Type Specifies the type of service.
Description Generic information about the service.
Customer Id The customer identifier.
Last Status Change The date and time of the most recent status change to this cus-
tomer.
Last Mgmt Change The date and time of the most recent management-initiated change
to this customer.
Admin State The administrative state of the service
Vc Switching Displays the status of VC switching .
SAP Count The number of SAPs specified for this service.
Uplink Type Displays the mode of the device.
Vpn Id The number which identifies the VPN.
Oper State The operational state of the service.
SAP Displays the SAP ID.
Encap The value of the label used to identify this SAP on the access port.
Vpn Id The number which identifies the VPN.
Oper State The operational state of the service.
SAP Displays the SAP ID.
To Next Page
Loading...
Need help?
General
