PBB Show Commands
7210-SAS M Services Guide Page 479
Sample
Sample output for PBB Epipe service:
*A:7210-SAS>show>service# id 1000 base
===============================================================================
Service Basic Information
===============================================================================
Service Id : 1000 Vpn Id : 0
Service Type : Epipe
Description : (Not Specified)
Customer Id : 1
Last Status Change: 04/04/2001 22:18:48
Last Mgmt Change : 04/04/2001 21:28:34
Admin State : Up Oper State : Up
MTU : n/a
MTU Check : n/a
Vc Switching : False
SAP Count : 1 SDP Bind Count : 0
Uplink Type: : MPLS
-------------------------------------------------------------------------------
Service Access & Destination Points
-------------------------------------------------------------------------------
Identifier Type AdmMTU OprMTU Adm Opr
-------------------------------------------------------------------------------
sap:1/1/15:1000 q-tag 1518 1518 Up Up
-------------------------------------------------------------------------------
PBB Tunnel Point
-------------------------------------------------------------------------------
B-vpls Backbone-dest-MAC Isid AdmMTU OperState Flood Oper-dest-MAC
-------------------------------------------------------------------------------
2 8c:90:d3:79:b2:65 1000 1514 Up Yes 8c:90:d3:79:b2:65
-------------------------------------------------------------------------------
Last Status Change: 04/04/2001 22:18:48
Last Mgmt Change: 04/04/2001 22:18:48
===============================================================================
PBB Tunnel Point
B-vpls Displays the B-VPLS ID.
Backbone-dest-MAC Displays the back bone destination MAC address.
Isid Displays the ISID number.
Flood Specifies whether or not the traffic is flooded in the B-VPLS for
the Destination instead of unicast. If the backbone destination
MAC is in theB-VPLS FDB, then it will be unicast.
b-Vpls Status Displays the operational state of the B-VPLS service
b-Vpls Id Displays the B-VPLS ID.