Alcatel-Lucent 7210 SAS M - Page 493

PBB Show Commands
7210-SAS M Services Guide Page 493
PBB Debug Commands
Id
Syntax id service-id
Context debug>service
Description This command debugs commands for a specific service.
Parameters service-id — The ID that uniquely identifies a service.
Values service-id: 1 — 214748364
event-type
Syntax [no] event-type {config-change | svc-oper-status-change | sap-oper-status-change}
Context debug>service>id
Description This command enables a particular debugging event type. The no form of the command disables the
event type debugging.
Parameters config-change — Debugs configuration change related events.
svc-oper-status-change — Debugs service operational status changes.
sap-oper-status-change — Debugs SAP operational status changes.
sap
Syntax [no] sap sap-id
Context debug>service>id
Description This command enables debugging for a particular SAP.
Parameters sap-id — Specifies the SAP ID.
stp
Syntax stp
Context debug>service>id
Description This command enables the context for debugging STP.