VPRN Service Configuration Commands
Page 604 7210 SAS M Services Guide
application
Syntax application app [ip-int-name|ip-address]
no application app
Context config>service>vprn>source-address
Description This command specifies the source address and application.
Parameters app — Specify the application name.
Values telnet, ssh, traceroute, ping
ip-int-name | ip-address — Specifies the name of the IP interface or IP address. If the string contains
special characters (#, $, spaces, etc.), the entire string must be enclosed within double quotes.
static-route
Syntax [no] static-route {ip-prefix/prefix-length | ip-prefix netmask} [preference preference] [metric
metric] [tag tag] [enable | disable] {next-hop ip-int-name | ip-address | ipsec-tunnel ipsec-
tunnel-name} [bfd-enable | {cpe-check cpe-ip-address [interval seconds] [drop-count
count] [log]}]
[no] static-route {ip-prefix/prefix-length | ip-prefix netmask} [preference preference] [metric
metric] [tag tag] [enable | disable] indirect ip-address [cpe-check cpe-ip-address [interval
seconds][drop-count count] [log]]
[no]
static-route {ip-prefix/prefix-length | ip-prefix netmask} [preference preference] [metric
metric] [tag tag] [enable | disable] black-hole
Context config>service>vprn
Description This command creates static route entries within the associated router instance. When configuring a
static route, either next-hop, indirect or black-hole must be configured.
The no form of the command deletes the static route entry. If a static route needs to be removed when
multiple static routes exist to the same destination, then as many parameters to uniquely identify the
static route must be entered.
If a CPE connectivity check target address is already being used as the target address in a different
static route, then cpe-check parameters must match. If they do not, the new configuration command
will be rejected.
If a static-route command is issued with no cpe-check target but the destination prefix/netmask and
next-hop matches a static route that did have an associated cpe-check, the cpe-check test will be
removed from the associated static route.
Default No static routes are defined.
Parameters ip-prefix — The destination address of the aggregate route in dotted decimal notation.
Values ipv4-prefix a.b.c.d (host bits must be 0)
ipv4-prefix-length 0 — 32
To Next Page
Loading...
