Virtual Private Routed Network Services
7210 SAS M Services Guide Page 603
single-sfm-overload
Syntax single-sfm-overload [holdoff-time holdoff-time]
no single-sfm-overload
Context config>service>vprn
Description This command, if enabled, will cause the IGP protocols (either IS-IS or OSPF) for the service to enter
an overload state when the node only has a single SFM functioning.
The no form of this command causes the overload state to be cleared.
Default no single-sfm-overload
Parameters holdoff-time — This parameter specifies the delay between the detection of a single SFM and
enacting the overload state.
Values 1—600 seconds
Default 0 seconds
snmp-community
Syntax snmp-community community-name [version SNMP-version]
no snmp-community [community-name]
Context config>service>vprn
Description This command sets the SNMP community name to be used with the associated VPRN instance.
If an SNMP community name is not specified, then SNMP access is not allowed.
The no form of the command removes the SNMP community name from the given VPRN context.
Default None — The SNMP community must be explicitly specified.
Parameters community-name — Specifies one or more SNMP community names.
version SNMP-version — Specifies the SNMP version.
Values v1, v2c, both
source-address
Syntax source-address
Context config>service>vprn
Description This command enables the context to specify the source address and application that should be used
in all unsolicited packets.