VPRN Service Configuration Commands
Page 648 7210 SAS M Services Guide
rp-candidate
Syntax rp-candidate
Context config>service>vprn>pim>rp
Description This command enables the context to configure the candidate rendezvous point (RP) parameters.
Default Enabled when PIM is enabled.
group-range
Syntax [no] group-range {grp-ip-address/mask | grp-ip-address [netmask]}
Context config>service>vprn>pim>rp>rp-candidate
config>service>vprn>pim>ssm
Description This command configures the group address or range of group addresses for which this router can be
the rendezvous point (RP).
Use the no form of this command to remove the group address or range of group addresses for which
this router can be the RP from the configuration.
Default none
Parameters group-ip-address — Specify the addresses or address ranges that this router can be an RP.
mask — Specify the address mask with the address to define a range of addresses.
netmask — Specify the subnet mask in dotted decimal notation.
Values 0.0.0.0 — 255.255.255.255 (network bits all 1 and host bits all 0)
holdtime
Syntax holdtime holdtime
no holdtime holdtime
Context config>service>vprn>pim>rp>rp-candidate
Description Use this command to define the length of time neighboring router consider this router to be up.
Use the no form of this command to revert to the default value.
Default 150
Parameters holdtime — Specify the length of time, in seconds, that neighbor should consider the sending router to
be operational.
Values 0 — 255
To Next Page
Loading...
Need help?
General
