Alcatel-Lucent 7210 SAS M Service Guide

Virtual Private Routed Network Services
7210 SAS M Services Guide Page 649
priority
Syntax priority priority
no priority priority
Context config>router>pim>rp>local
config>service>vprn>pim>rp>rp-candidate
Description This command defines the priority used to become the rendezvous point (RP). The higher the priority
value, the more likely that this router will become the RP.
Use the no form of this command to revert to the default value.
Default 1
Parameters priority — Specify the priority to become the designated router. The higher the value the more likely
the router will become the RP.
Values 0 — 255
static
Syntax static
Context config>service>vprn>pim>rp
Description This command enables access to the context to configure a static rendezvous point (RP) of a PIM-SM
protocol instance.
Default none
address
Syntax [no] address ip-address
Context config>service>vprn>pim>rp>static
Description This command configures the static rendezvous point (RP) address.
The override option specifies that dynamically learned RPs have less priority then this static entry, by
default dynamic learned RPs take preference over static configured RPs.
The no form of this command removes the static RP entry from the configuration.
Default none

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English