VPRN Service Configuration Commands
Page 668 7210 SAS M Services Guide
This configuration parameter can be set at three levels: global level (applies to all peers), group level
(applies to all peers in peer-group) or neighbor level (only applies to specified peer). The most
specific value is used.
The no form of the command used at the global level reverts to default where the MED is not
advertised.
The no form of the command used at the group level reverts to the value defined at the global level.
The no form of the command used at the neighbor level reverts to the value defined at the group level.
Default no med-out
Parameters number — The MED path attribute value, expressed as a decimal integer.
Values 0 — 4294967295
igp-cost — The MED is set to the IGP cost of the given IP prefix.
min-as-origination
Syntax min-as-origination seconds
no min-as-origination
Context config>service>vprn>bgp
config>service>vprn>bgp>group
config>service>vprn>bgp>group>neighbor
Description This command configures the minimum interval, in seconds, at which a path attribute, originated by
the local router, can be advertised to a peer.
This configuration parameter can be set at three levels: global level (applies to all peers), group level
(applies to all peers in peer-group) or neighbor level (only applies to specified peer). The most
specific value is used.
The no form of the command used at the global level reverts to default.
The no form of the command used at the group level reverts to the value defined at the global level.
The no form of the command used at the neighbor level reverts to the value defined at the group level.
Default 15 seconds
Parameters seconds — The minimum path attribute advertising interval in seconds, expressed as a decimal
integer.
Values 2 — 255
To Next Page
Loading...
Need help?
General
