Virtual Private Routed Network Services
7210 SAS M Services Guide Page 669
min-route-advertisement
Syntax min-route-advertisement seconds
no min-route-advertisement
Context config>service>vprn>bgp
config>service>vprn>bgp>group
config>service>vprn>bgp>group>neighbor
Description This command configures the minimum interval, in seconds, at which a prefix can be advertised to a
peer.
This configuration parameter can be set at three levels: global level (applies to all peers), group level
(applies to all peers in peer-group) or neighbor level (only applies to specified peer). The most
specific value is used.
The no form of the command reverts to default values.
Default 30 seconds
Parameters seconds — The minimum route advertising interval, in seconds, expressed as a decimal integer.
Values 1— 255
multihop
Syntax multihop ttl-value
no multihop
Context config>service>vprn>bgp
config>service>vprn>bgp>group
config>service>vprn>bgp>group>neighbor
Description This command configures the time to live (TTL) value entered in the IP header of packets sent to an
EBGP peer multiple hops away.
This parameter is meaningful only when configuring EBGP peers. It is ignored if set for an IBGP
peer.
The no form of the command is used to convey to the BGP instance that the EBGP peers are directly
connected.
The no form of the command reverts to default values.
Default 1 — EBGP peers are directly connected.
64 — IBGP
Parameters ttl-value — The TTL value, expressed as a decimal integer.
Values 1 — 255
To Next Page
Loading...
Need help?
General
