Service Commands
7210 SAS M Services Guide Page 679
Note : SDP commands are not supported by 7210 SAS-M devices configured in Access uplink mode.
Syntax sdp [sdp-id | far-end ip-address] [detail | keep-alive-history]
Context show>service
Description This command displays SDP information.
If no optional parameters are specified, a summary SDP output for all SDPs is displayed.
Parameters sdp-id — The SDP ID for which to display information.
Default All SDPs.
Values 1 — 17407
far-end ip-address — Displays only SDPs matching with the specified far-end IP address.
Default SDPs with any far-end IP address.
detail — Displays detailed SDP information.
Default SDP summary output.
keep-alive-history — Displays the last fifty SDP keepalive events for the SDP.
Default SDP summary output.
Output Show Service SDP — The following table describes show service SDP output fields.
Label Description
SDP Id
The SDP identifier.
Description
Displays a text string describing the SDP.
Admin Path MTU
Displays the desired largest service frame size (in octets) that can be trans-
mitted through this SDP to the far-end ESR, without requiring the packet to
be fragmented. The default value of zero indicates that the path MTU should
be computed dynamically from the corresponding MTU of the tunnel.
Opr Path MTU
Displays the actual largest service frame size (in octets) that can be transmit-
ted through this SDP to the far-end ESR, without requiring the packet to be
fragmented. In order to be able to bind this SDP to a given service, the value
of this object minus the control word size (if applicable) must be equal to or
larger than the MTU of the service, as defined by its service MTU.
Far End
Displays the far end IP address.
Delivery
The type of delivery used by the SDP: MPLS.
IP address
Specifies the IP address of the remote end of the MPLS tunnel defined by
this SDP.
Adm
Admin State
The desired state of the SDP.
To Next Page
Loading...
Need help?
General
