EasyManuals Logo

Alcatel-Lucent 7210 SAS M Service Guide

Alcatel-Lucent 7210 SAS M
952 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #680 background imageLoading...
Page #680 background image
Show, Clear, Debug Commands
Page 680 7210 SAS M Services Guide
Opr
Oper State
The operating state of the SDP.
Flags
Specifies all the conditions that affect the operating status of this SDP.
Signal
Signaling
The signaling protocol used to obtain the ingress and egress labels used in
frames transmitted and received on the SDP.
Last Status Change
The time of the most recent operating status change to this SDP.
Adv. NTU Over
Specifies whether the advertised MTU of a VLL spoke SDP bind includes
the 14-byte L2 header, so that it is backward compatible with pre-2.0 soft-
ware.
Last Mgmt Change
The time of the most recent management-initiated change to this SDP.
KeepAlive Infor-
mation
This section displays Keepalive information.
Hello Time
Specifies how often the SDP echo request messages are transmitted on this
SDP.
Hello Msg Len
The length of the SDP echo request messages transmitted on this SDP.
Hello Timeout
The number of seconds to wait for an SDP echo response message before
declaring a timeout.
Unmatched Replies
The number of SDP unmatched message replies timer expired.
Max Drop Count
The maximum number of consecutive SDP echo request messages that can
be unacknowledged before the keepalive protocol reports a fault.
Hold Down Time
The amount of time to wait before the keepalive operating status is eligible
to enter the alive state.
TX Hello Msgs
The number of SDP echo request messages transmitted since the keepalive
was administratively enabled or the counter was cleared.
Rx Hello Msgs
The number of SDP echo request messages received since the keepalive was
administratively enabled or the counter was cleared.
Associated LSP
List
When the SDP type is MPLS, a list of LSPs used to reach the far-end router
displays. All the LSPs in the list must terminate at the IP address specified in
the far end field.
Lsp Name
Displays the LSP name.
Time Since Last
Transaction
Displays the time of the last transaction.
Signaling
Specifies the signaling type.
Label Description (Continued)

Table of Contents

Other manuals for Alcatel-Lucent 7210 SAS M

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alcatel-Lucent 7210 SAS M and is the answer not in the manual?

Alcatel-Lucent 7210 SAS M Specifications

General IconGeneral
BrandAlcatel-Lucent
Model7210 SAS M
CategorySwitch
LanguageEnglish

Related product manuals