Alcatel-Lucent 7210 SAS M - Page 684

Show, Clear, Debug Commands
Page 684 7210 SAS M Services Guide
service-using
Syntax service-using [epipe][vpls] [m-vpls] [sdp sdp-id] [customer customer-id]
Context show>service
Description This command displays the services matching certain usage properties. If no optional parameters are
specified, all services defined on the system are displayed.
Parameters epipe — Displays matching Epipe services.
vpls — Displays matching VPLS instances.
sdp sdp-id — Displays only services bound to the specified SDP ID.
Default Services bound to any SDP ID.
Values 1 — 17407
customer customer-id — Displays services only associated with the specified customer ID.
Default Services associated with a customer.
Values 1 — 2147483647
Output Show Service Service-Using — The following table describes show command output fields.
Sample Output
*A:ALA-12# show service service-using customer 10
==============================================================================
Services
==============================================================================
ServiceId Type Adm Opr CustomerId Last Mgmt Change
------------------------------------------------------------------------------
1 VPLS Up Up 10 09/05/2006 13:24:15
300 Epipe Up Up 10 09/05/2006 13:24:15
------------------------------------------------------------------------------
Matching Services : 2
==============================================================================
*A:ALA-12#
Label Description
Service Id
The service identifier.
Type
Specifies the service type configured for the service ID.
Adm
The desired state of the service.
Opr
The operating state of the service.
CustomerID
The ID of the customer who owns this service.
Last Mgmt Change
The date and time of the most recent management-initiated change to
this service.