Service Commands
7210 SAS M Services Guide Page 689
Sample Output
A:dut-b# show eth-cfm association
======================================================================
CFM Association Table
======================================================================
Md-index Ma-index Name CCM-interval Bridge-id
----------------------------------------------------------------------
1 1 a1 1 1
1 2 a2 1 2
2 1 a1 1 2
2 2 a2 1 1
======================================================================
A:dut-b#
cfm-stack-table
Syntax cfm-stack-table [{all-ports}] [level <0..7>] [direction <down>]
cfm-stack-table port <port-id> [vlan <qtag[.qtag]>] [level <0..7>] [direction <down>]
cfm-stack-table facility [{all-ports|all-lags|all-lag-ports|all-tunnel-meps|all-router-
interfaces}] [level <0..7>] [direction <down>]
cfm-stack-table facility lag <id> [tunnel <1..4094>] [level <0..7>] [direction <down>]
cfm-stack-table facility port <id> [level <0..7>] [direction <down>]
cfm-stack-table facility router-interface <ip-int-name> [level <0..7>] [direction <down>]
Context show>eth-cfm
Description This command displays stack-table information. This stack-table is used to display the various management
points MEPs and MIPs that are configured on the system. These can be Service based or facility based. The
various option allow the operator to be specific. If no parameters are include then the entire stack-table will
be displayed.
Parameters port port-id — Displays the bridge port or aggregated port on which MEPs or MHFs are configured.
vlan vlan-id — Displays the associated VLAN ID.
level — Display the MD level of the maintenance point.
Values 0 — 7
direction down — Displays the direction in which the MP faces on the bridge port.
facility — Displays the CFM stack table information for facility MEPs. The base command will display all
the facility MEPs. Options may be included in order to further parse the table for specific facility MEP
information.
Output Show eth-cfm CFM Stack Table Command Output — The following table describes show eth-cfm
CFM stack table command output fields:
To Next Page
Loading...
