IES Show Commands
7210-SAS M Services Guide Page 701
------------------------------------------------------------------------------
Multi Service Site
------------------------------------------------------------------------------
Site : west
Description : (Not Specified)
==============================================================================
*A:ALA-12#
*A:ALA-12# show service customer 274 site west
==============================================================================
Customer 274
==============================================================================
Customer-ID : 274
Contact : Mssrs. Beaucoup
Description : ABC Company
Phone : 650 123-4567
------------------------------------------------------------------------------
Multi Service Site
------------------------------------------------------------------------------
Site : west
Description : (Not Specified)
Assignment : Card 5
I. Sched Pol: SLA1
E. Sched Pol: (Not Specified)
------------------------------------------------------------------------------
Service Association
------------------------------------------------------------------------------
No Service Association Found.
==============================================================================
*A:ALA-12#
sap-using
Syntax sap-using [sap sap-id]
sap-using interface [ip-address | ip-int-name]
sap-using [ingress | egress] filter filter-id
sap-using [ingress ] qos-policy qos-policy-id
Context show>service
Description Displays SAP information.
If no optional parameters are specified, the command displays a summary of all defined SAPs. The
optional parameters restrict output to only SAPs matching the specified properties.
Parameters sap sap-id — Specifies the physical port identifier portion of the SAP definition. See Common CLI
Command Descriptions on page 939 for command syntax.
ingress — Specifies matching an ingress policy.
egress — Specifies matching an egress policy.
filter filter-id — The ingress or egress filter policy ID for which to display matching SAPs.
Values 1 — 65535
interface — Specifies matching SAPs with the specified IP interface.
To Next Page
Loading...
