Alcatel-Lucent 7210 SAS M Service Guide

Show, Clear, Debug Commands
Page 702 7210-SAS M Services Guide
ip-addr — The IP address of the interface for which to display matching SAPs.
Values 1.0.0.0 — 223.255.255.255
ip-int-name — The IP interface name for which to display matching SAPs.
Output Show Service SAP — The following table describes show service SAP output fields:
Sample Output
*A:DUT-B# show service sap-using sap 1/1/3:100.*
=========================================================================
Service Access Points
=========================================================================
PortId SvcId Ing. Ing. Egr. Adm Opr
QoS Fltr Fltr
-------------------------------------------------------------------------
1/1/1 6 1 none none Up Down
1/1/2 700 1 none none Up Down
-------------------------------------------------------------------------
Number of SAPs : 2
=========================================================================
*A:DUT-B#
Label Description
Port ID
The ID of the access port where the SAP is defined.
Svc ID
The value that identifies the service.
SapMTU
The SAP MTU value.
Igr.QoS
The SAP ingress QoS policy number specified on the ingress SAP.
Ing.Fltr
The MAC or IP filter policy ID applied to the ingress SAP.
E.QoS
The SAP egress QoS policy number specified on the egress SAP.
Egr.Fltr
The MAC or IP filter policy ID applied to the egress SAP.
A.Pol
The accounting policy ID assigned to the SAP.
Adm
The administrative state of the SAP.
Opr
The actual state of the SAP.

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English