IES Show Commands
7210-SAS M Services Guide Page 705
Service Destination Points (SDPs)
SDP Id
The SDP identifier.
Type
Indicates whether this Service SDP binding is a spoke or a mesh.
Admin Path MTU
The largest service frame size (in octets) that can be transmitted through
this SDP to the far-end router, without requiring the packet to be frag-
mented.
Oper Path MTU
The actual largest service frame size (in octets) that can be transmitted
through this SDP to the far-end router, without requiring the packet to
be fragmented.
Delivery
Specifies the type of delivery used by the SDP: GRE or MPLS.
Admin State
The administrative state of this SDP.
Oper State
The operational state of this SDP.
Ingress Label
The label used by the far-end device to send packets to this device in
this service by this SDP.
Egress Label
The label used by this device to send packets to the far-end device in
this service by this SDP.
Ingress Filter
The ID of the ingress filter policy.
Egress Filter
The ID of the egress filter policy.
Far End
Specifies the IP address of the remote end of the GRE or MPLS tunnel
defined by this SDP.
Last Changed
The date and time of the most recent change to this customer.
Signaling
Specifies the signaling protocol used to obtain the ingress and egress
labels used in frames transmitted and received on this SDP.
Admin State
Specifies the operating status of the service.
Oper State
The current status of the service.
Hello Time
Specifies how often the SDP echo request messages are transmitted on
this SDP.
Hello Msg Len
Specifies the length of the SDP echo request messages transmitted on
this SDP.
Max Drop Count
Specifies the maximum number of consecutive SDP Echo Request mes-
sages that can be unacknowledged before the keepalive protocol reports
a fault.
Hold Down Time
Specifies the amount of time to wait before the keepalive operating sta-
tus is eligible to enter the alive state.
Label Description (Continued)
To Next Page
Loading...
Need help?
General
