Show, Clear, Debug Commands
Page 716 7210-SAS M Services Guide
-------------------------------------------------------------------------------
192.168.1.2 00:00:01:00:00:01 Other 00h00m00s HW 1/1/1:10*
195.168.1.1 32:67:01:01:00:03 Other 00h00m00s to7x 1/1/3:10*
195.168.1.2 32:68:01:01:00:02 Dynamic 03h59m58s to7x 1/1/3:10*
===============================================================================
*A:DUT-B#
base
Syntax base
Context show>service>id
Description This command displays basic information about this IES service.
Sample Output
*A:ALA-A# show service id 100 base
---------------------------------------------------------------
Service Basic Information
---------------------------------------------------------------
Service Id : 100 Vpn Id : 100
Service Type : IES
Description : Default Ies description for service id 100
Customer Id : 1
Last Status Change: 08/29/2006 17:44:28
Last Mgmt Change : 08/29/2006 17:44:28
Admin State : Up Oper State : Up
SAP Count : 2
-------------------------------------------------------------------------------
Service Access & Destination Points
-------------------------------------------------------------------------------
Identifier Type AdmMTU OprMTU Adm Opr
-------------------------------------------------------------------------------
sap:1/1/3 null 1514 1514 Up Up
sap:1/1/4 null 1514 1514 Up Up
===============================================================================
*A:ALA-A#
interface
Syntax interface [ip-address | ip-int-name] [detail]
Context show>service>id
Description This command displays information for the IP interfaces associated with the IES service. If no
optional parameters are specified, a summary of all IP interfaces associated to the service are
displayed.
Parameters ip-address — The IP address of the interface for which to display information.
Values ipv4-address: a.b.c.d (host bits must be 0)
ip-int-name — Specifies the IP interface name for which to display information.
To Next Page
Loading...
Need help?
General
