Alcatel-Lucent 7210 SAS M Service Guide

Show, Clear, Debug Commands
Page 722 7210-SAS M Services Guide
sap-using
Syntax sap-using [sap sap-id]
sap-using interface [ip-address | ip-int-name]
sap-using [ingress | egress] filter filter-id
sap-using [ingress | egress] qos-policy qos-policy-id
Context show>service
Description This command displays SAP information.
If no optional parameters are specified, the command displays a summary of all defined SAPs.
The optional parameters restrict output to only SAPs matching the specified properties.
Parameters sap-id — Specifies the physical port identifier portion of the SAP definition. See Common CLI
Command Descriptions on page 939 for command syntax.
interface — Specifies matching SAPs with the specified IP interface.
ip-address — The IP address of the interface for which to display matching SAPs.
Values 1.0.0.0 — 223.255.255.255
ip-int-name — The IP interface name for which to display matching SAPs.
ingress — Specifies matching an ingress policy.
egress — Specifies matching an egress policy.
qos-policy qos-policy-id — The ingress or egress QoS Policy ID for which to display matching
SAPs.
Values 1 — 65535
filter filter-id — The ingress or egress filter policy ID for which to display matching SAPs.
Values 1 — 65535
Output Show Service SAP — The following table describes show service SAP output fields:
Label Description
Port ID
The ID of the access port where the SAP is defined.
Svc ID
The service identifier.
SapMTU
The SAP MTU value.
I.QoS
The SAP ingress QoS policy number specified on the ingress SAP.
I.MAC/IP
The MAC or IP filter policy ID applied to the ingress SAP.
E.QoS
The SAP egress QoS policy number specified on the egress SAP.
E.Mac/IP
The MAC or IP filter policy ID applied to the egress SAP
A.Pol
The accounting policy ID assigned to the SAP.
Adm
The desired state of the SAP.

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English